20/18 mm black buffalo grain genuine leather strap with white stitching to fit TAG Heuer Monza re-issue model CR5112. Please read clasp fitment details.

20/18 mm black buffalo grain genuine leather strap with white stitching to fit TAG Heuer Monza re-issue model CR5112 ONLY. PLEASE NOTE THAT THEY WILL NOT FIT ANY OF THE OTHER MONZA MODELS.

VERY IMPORTANT: Please read the following information before placing your order:

1. A clasp is NOT included with this strap. You need to transfer the deployment clasp over from your old strap.

2. PLEASE CHECK the model number of your deployment clasp. It is marked on the clasp itself, usually on one of the deployment arms, and will start with the letters FC. The markings are quite small so you need to look closely - and remember to look on both sides of the arms. ALL genuine TAG Heuer clasps have a model number marked on them. This strap is ONLY compatible with the following clasp model numbers:

- FC5037
- FC5039
- FC5040
- FC5041
- FC5045
- FC5049
- FC5053
- FC5055
- FC5065

All other TAG Heuer clasps have a lower clasp clamp height (2 mm vs 3 mm for those listed above), and this strap will not fit through their clasp clamps as a result.

3. If your watch currently has a metal bracelet you will need a new 18 mm deployment clasp, as the clasp from a metal bracelet cannot be used with a leather strap. Suitable clasps can be found under the Clasp & Buckles category.

4. This strap CANNOT be used with a pin buckle, as it has neither holes, loops nor a cutout for the pin.

The straps are 20 mm wide at the watch end, tapering down to 18 mm at the clasp end. Section lengths are 104 mm & 84 mm respectively. Thickness is approximately 6.25 mm at the watch end and 3.2 mm at the tail. The straps have black calf leather lining.

We offer a twelve-month replacement guarantee on these straps - if the strap is defective in any way, simply return it to us and we will send you a replacement free of charge.